FUSE REPLACEMENT , STOPLIGHT SWITCH ADJUSTMENT


JAPANESE  INDEX  TOP

FUSE REPLACEMENT

( Refer to the maintenance precaution. )

The fuse holder (1) is attached to the battery case cover.

The specified fuse is:

  • 7A ( UY type)
  • 10A ( UB , NZ type )

When frequent fuse failure occurs, it usually indicates a short circuit
or an overload in the electrical system. See your authorized Honda dealer
for repair.

CAUTION
Turn the ignition switch OFF before checking or replacing the fuses to
prevent accidental shortcircuiting.
WARNING
Never use a fuse with a different rating from that specified. Serioous
damage to the electrical system or a fire may result, causing a dangerous
loss of lights or engine power.

(1)Fuse holder (2)Spare fuse

To replace the fuse, open the fuse holder and lift out the fuse with the
clips (2) . Slide the old fuse out of the clips and discard it. Slide the
clips onto the ends of the new fuse, push them back into the fuse holder,
and close the fuse holder.

(2) Clips

CAUTION
Do not pry the clips open to get a fuse out: you could bend them and cause
poor contact with the new fuse. A loose fuse could cause damage to the
electrical system and even start a fire.

STOPLIGHT SWITCH ADJUSTMENT

( Refer to the maintenance precaution. )

Check the operation of the stoplight switch (1) at the right side behaind
the engine from time to time. Adjustment is done by turning the adjusting
nut (2). Turn the nut in the direction (A) if the switch operates too late
and in direction (B) if the switch operates too soon.

(1) Stoplight switch (2) Adjusting nut

JAPANESE  INDEX  TOP

コメント

タイトルとURLをコピーしました